Caliber MCD795 Anleitung zur Fehlerbehebung PDF herunterladen (Seite 67)

Once you have entered both numbers, press Done to make the selection.

Tip: The quickest way to tell the coordinates of a point is to select it by tapping on the

map or by using Find, and then come to this page and read the coordinates.

Tip: If you need to reformat coordinates to the format selected in this GPS device,

enter the coordinates in the format you have, press Done to show it in the map, then

come back here to see the same location in the chosen coordinate display format.

5.3.4 Find a POI

You can select your destination from the thousands of POIs included with this GPS

device or from the ones you have previously created. This screen helps you find the

one you are looking for. POI items are categorized to let you locate them more

easily. On this screen you can see the first page of the top level POI categories.

There are three levels altogether.

The search will be carried out around a certain reference point. Always look at the

current reference point shown in the green field above the POI category buttons and

confirm that it matches what you want. To change the reference, tap the Change ref.

button in the top right corner.

Once you tap the Change ref. button, you are presented with these choices:

• Address: you can specify an address to be searched around, or a settlement to

search in. The centre of this settlement will be used as the reference point.

• History: the reference for the search can be selected from the History list.

• Coordinates: you can specify a latitude/longitude pair to be the centre of the

search.

• GPS Position: the search will be carried out around the current location given by

the GPS if it is available. If no GPS position is available, the last known GPS

position (grey arrow on the map) will be used.

• Cursor: the search will be carried out around the previously selected map point.

• Destination: the search will be carried out around the destination of your current

route.

The current selection is always shown in the green field at the top of the page.

Note: The default reference point for POI search is the current GPS position, if it is

available, or the Cursor, when there is no reliable GPS position.

Once you have set the reference point, you have the following options on the Find

POI screen:

• Find in POI su/jointfilesconvert/398394/bgroups: highlight one of the POI groups by tapping or using the

direction buttons, then press Enter or tap it again to see the list of su/jointfilesconvert/398394/bgroups.

Using the same action you can move deeper into su/jointfilesconvert/398394/bgroups.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 73

Keine Kommentare

Caliber MCD795 Anleitung zur Fehlerbehebung Seite 67