Caliber MCD795 Anleitung zur Fehlerbehebung PDF herunterladen (Seite 57)

Road system that will mostly suppress these position errors by aligning your position

to the recommended route and the road network of the map, sometimes the errors

are too large to correct.

To reduce the effect of large errors, you can increase the recalculation tolerance two

ways.

Off-route sensitivity

This is a range of relative values from 0 to 10, telling this GPS device how far the

GPS position should be from the recommended route before the program decides to

recalculate. Lower values make this GPS device insensitive to position errors; higher

values will result in quicker reactions.

Recalculation delay

This is a setting that helps suppress the effects of position fluctuation. With a few

seconds delay in recalculation even large position jumps can be survived without a

need for route recalculation.

4.6.4.2 U-turn penalty

You can fine-tune the way this GPS device takes U-turns into account when planning

a route. You can tell this GPS device how much extra distance you would travel to

avoid a U-turn.

Note: This value is taken into account only if U-turns are enabled in Route

Parameters .

4.6.4.3 Cross-border planning

By default this GPS device plans routes using the border crossing points. However,

if you live near the border, you can disable border crossing with this switch to remain

within one country.

4.6.4.4 Carpool Lanes(For USA only)

You can instruct this GPS device to use carpool lanes when planning routes. These

lanes are currently available in the USA only.

This control only appears on the screen when the USA map is available in the

product

4.6.4.5 Keep position on road (Lock-on-Road)

This GPS device is normally used for vehicle navigation, therefore Lock-on-Road will

display the position arrow precisely over roads, seamlessly correcting small GPS

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 72 73

Keine Kommentare

Caliber MCD795 Anleitung zur Fehlerbehebung Seite 57